Progressive Turf Equipment TDR-30 Operator's Manual And Parts List page 21

When hydraulic functions are used during the assembly process, both the main wing cylinders &
outer wing cylinders will activate. The outer wing cylinders are strapped to the side of the main wing
and can be left in this position until the outer wing decks are installed.
7) Lower the wing until the deck swivel mounting points align with the bushings on the wing deck swivel.
Re-install the painted 1-1/4" pins through the bushings and deck swivel. Secure the pins in place using
the 3/8" bolts previously removed.
8) Install deck stop chains on wing decks
9) When it is safe to do so, fully raise the decks and secure each deck in the transport position with the
corresponding deck locks. Ensure the deck locks function properly without binding and engage the
matching lug on the wing arm properly. Insert the lock pins in the transport position before moving the
mower (Page 33)
10) Inspect the front and rear stand-off arms and ensure that they engage the deck lock mounts properly. If
required, lower deck to ground, loosen (3) mounting bolts on frame, adjust location of stand-off pin
accordingly and re-tighten bolts. Raise deck and re-check stand-off engagement.
11) Remove the TDR Spreader Fixture (526498).
12) When safe to do so, release the transport locks and carefully lower the decks to the ground.
TDR-30 Operator's Manual
Shipping Links to
be Removed
19