Spindle Service - Progressive Turf Equipment TDR-30 Operator's Manual And Parts List

TDR-30 Operator's Manual

SPINDLE SERVICE

Each spindle is supported by two ball bearings. No adjustment of
clearance is required.
assembly by tightening the 1" NF left hand nut on top of the pulley.
Periodically inspect blade spindles by grasping pulley, and moving
from side to side. If any free play is noted, replace or repair.
SPINDLE ASSEMBLY REMOVAL
1) With the mower decks in the transport position, remove the
blade.
2) Lower decks to mowing position.
3) Relieve belt tension and remove belt from the spindle pulley.
4) Place a piece of cardboard or other soft material on the
ground beneath the spindle to be removed.
5) From above the deck, loosen & remove the four nuts that
hold the spindle assembly to the deck. The spindle assembly
will drop on to the ground.
6) Remove the complete spindle assembly from beneath the
deck.
SPINDLE ASSEMBLY INSTALLATION
Reverse above procedure. Be sure spindle mounting area of deck
is clean of any foreign material before attaching spindle assembly.
Never direct high pressure water spray at the blade spindles
(top or bottom). Water may enter the bearings, compromising
and lead to premature failure.
48
Running clearance is pre-set during