Table of Contents
Advertisement
3. Press ALT-ESC to toggle to the server console, and enter the following LOAD
statements (make sure that the diskette that you created in step 1 is inserted
in drive A):
LOAD A:\NOVELL\NETWARE\MSM.NLM
LOAD A:\NOVELL\NETWARE\TOKENTSM.NLM
4. Press ALT-ESC to toggle back to the INSTALL panel.
5. Press F3 on the next panel to specify A:\NOVELL\NETWARE as the directory
path.
Press Enter, then follow the instructions on the panel to complete the
installation of the driver. If you need to make any custom configuration
changes to the driver, do so at this time.
6. Follow the instructions in the Novell manual to Create an AUTOEXEC.NCF file .
In addition to the instructions in the manual, add the following lines to the
AUTOEXEC.NCF file immediately after the IPX INTERNAL NET statement (if
necessary, replace C:\NWSERVER with the location of the SERVER.EXE
executable):
LOAD C:\NWSERVER\NBI.NLM
LOAD C:\NWSERVER\MSM.NLM
LOAD C:\NWSERVER\TOKENTSM.NLM
LOAD C:\NWSERVER\IBMTOKEN.LAN NAME=IBMLS1 DATARATE=M16
Note: There will be existing LOAD and BIND IPX statements in the
AUTOEXEC.NCF. Delete the LOAD statement (we have replaced it with
stated LOAD C:\NWSERVER\IBMTOKEN.LAN statement). Also, make
any needed modifications to the existing BIND IPX statement (refer to
the Bind the Protocol to the LAN Driver section of the Novell manual for
additional information).
See "Novell NetWare Server Driver Parameters" on page 20 for a complete list
of parameters that can be specified on the LOAD IBMTOKEN command in the
AUTOEXEC.NCF file.
7. Press ESC and answer YES to save the new file to disk. Press ESC again to
return to the server console.
8. Type the following commands from the server prompt to shut down the server
and exit to DOS: down, then exit.
9. Perform the following COPY commands, making sure that the diskette that you
created in step 1 is inserted in drive A. Note that it will prompt you at each of
the following files to ask if you want to perform a file overwrite; it is OK to
overwrite these files.
COPY A:\NOVELL\NETWARE\NBI.NLM C:\NWSERVER
COPY A:\NOVELL\NETWARE\MSM.NLM C:\NWSERVER
COPY A:\NOVELL\NETWARE\TOKENTSM.NLM C:\NWSERVER
COPY A:\NOVELL\NETWARE\IBMTOKEN.LAN C:\NWSERVER
COPY A:\NOVELL\NETWARE\IBMTOKEN.LDI C:\NWSERVER
10. Go to the Novell server directory and enter server at the DOS prompt to
restart the server.
11. Install the latest available Novell patches for NetWare 4.11 now. Make sure to
select the Version 3.31 ODI LAN Updates for Hardware if given the opportunity.
12. Issue the following commands from the server prompt to bring the server
down, then restart it: down, then restart server.
13. Installation is now complete. Check for the following conditions to determine
whether the adapter is working correctly and whether installation is complete:
v The device driver files are loading successfully.
v There are no error messages.
Chapter 4. Software Installation
15
Advertisement
Table of Contents
