IBM Turbo 16/4 Token-Ring PC Card 2 User Manual page 79

Error Code
LTG0025I
LTG0026I
LTG0027I
Explanation and Action
A configuration error was found in PROTOCOL.INI.
Explanation:
Conflicting parameter values were found while
the installation program was processing the
IBM Token-Ring Network Driver section of
PROTOCOL.INI.
User Action:
Examine the configuration parameters and
correct the conflicting values in
PROTOCOL.INI.
The PC Card is not responding or was not found.
Explanation:
One of the following conditions has caused
this error:
v The logical primary or alternate setting in
the PROTOCOL.INI file does not map to
the physical primary or alternate setting.
v The PC Card is not responding to a
request to start.
v There is no physical PC Card in your
computer.
User Action:
If there is already a PC Card in this system,
check the logical primary or alternate setting.
Check the cable and ensure that the
connection to the token-ring network
addressable unit is functioning correctly. Then,
run the hardware diagnostics for the
token-ring PC Card to ensure that the PC
Card and options have been installed
correctly.
If there is no PC Card in your computer,
install a token-ring PC Card or remove the
device driver statement from the
CONFIG.SYS file.
The protocol manager could not be opened.
Explanation:
An unexpected error occurred when the
program attempted to open the protocol
manager.
User Action:
Check the drive and directory to ensure that
the protocol manager is located in the
specified path.
Appendix B. Problem Determination
63