Transmit Error Codes - IBM Turbo 16/4 Token-Ring PC Card 2 User Manual

Recommended Actions Table
Table 8. Recommended Actions
Number
1
2
2a
2b
3
4
5

Transmit Error Codes

If you experience time-out errors during the on-ring test, try running the wrap test in
the diagnostics. If the wrap test is completed successfully, but the on-ring test fails,
it might indicate problems on the Token-Ring network that the adapter is opening
onto during the on-ring test.
For any other errors, ensure that the adapter and cabling are properly connected,
and retry the test. If the adapter continues to fail, record the error and contact your
network administrator.
01
08
22
23
24
25
26
27
28
29
40
41
86
Turbo 16/4 Token-Ring PC Card 2
Description
After delaying at least 30 seconds, retry the open two times,
inserting the same delay between each try.
After delaying at least 30 seconds, check the PC Card configuration
(especially the PC Card data rate) and retry the open.
If this error persists, contact your network administrator for
assistance and provide Open Error information.
If this error persists, contact your network administrator for
assistance.
Contact your network administrator for assistance and provide Open
Error information.
Contact your network administrator for assistance and provide Node
Address information, and try attaching to the ring after 6 minutes.
If this error persists, problem determination of the PC Card or lobe is
necessary. Contact your network administrator for problem
determination assistance.
Unrecognized command code
Unauthorized access priority
Error on frame transmission, examine STRIPPED_FS
Error on frame transmit or strip process
Unauthorized MAC frame
Maximum commands exceeded
Correlator not acceptable
Link not transmitting I frames, status changed from link open
Transmit frame length not acceptable
Link retransmission in process, buffers free
Station ID not acceptable
Protocol error, link not in acceptable state for command