Table of Contents
Advertisement
Table 2. Do not use LANAID to configure your machine (continued)
Windows NT 3.51
Windows NT 4.0
and NT 4.0
If you are using the environment listed in Table 3, you will use LANAID to configure
your machine. Even though the network operating system appears to fully install
and configure the device driver, it is highly recommended that you run LANAID to
ensure that the PC Card is appropriately configured.
Table 3. Use LANAID to configure your machine
Microsoft Windows for Workgroups/NDIS 2
Note: If you are operating in a server environment, you might not get support from
Novell Installation
Novell NetWare Server Driver and PCMCIA Bus Support
Card Services and Point Enablers: What Works and What Does
Not
IBMTOKEN.LAN is used in both the NetWare Server and Client environments. In
order to use this driver, your system must enable the card by loading: Socket
Services, Card Services, and CS20TOK.EXE. POINTTR.EXE is not supported with
IBMTOKEN.LAN.
If Card Services on your system is earlier than version 5.00, enter the following
parameter when you load the driver: MEM1=<SRAM Address>
LOAD IBMTOKEN.LAN FRAME=TOKEN-RING MEM1=C8000
If you do not put this parameter on the driver load line, you will be prompted for this
parameter every time you load the driver.
If your Card Services is version 5.00 or higher, you do not need to worry about this
parameter.
CS20TOK.EXE Configuration
CS20TOK.EXE is a small software program that configures the PC Card socket
controller to allocate resources (memory, I/O Ports, interrupts, DMA channels, and
10
Turbo 16/4 Token-Ring PC Card 2
your hardware or network operating system manufacturers.
page 19
page 19
page 23
page 24
page 25
page 25
page 25
page 26
page 27
page 28
page 27
Advertisement
Table of Contents
