Open Errors - IBM Turbo 16/4 Token-Ring PC Card 2 User Manual

One of the following codes will be shown to indicate the results of the initialization
test. The error codes are displayed in hexadecimal format and represent the
BRING_UP_CODE set by the adapter.
0000
0014
0020
0022
0024
0026
0028
002A
002C
0040
0042
0044
0046
0048

Open Errors

Failure during the adapter open test might indicate that the adapter is not properly
configured to run on the network it is trying to open onto or that the adapter is not
properly configured for the system. The open test provides a return code and an
open error code. If the return code is 07, then see "Open Error Codes" on page 83
for a more accurate description of the failure and suggested actions. If the return
code is a value other than 00 or 07, problem determination of the PC Card and the
diagnostics is necessary. Record the error and contact your network administrator.
00
01
03
05
07
30
32
33
34
82
Turbo 16/4 Token-Ring PC Card 2
Initialization success
No microcode
Diagnostics could not be executed
ROM diagnostics failed
Shared RAM diagnostics failed
Processor instruction test failed
Processor interrupt test failed
Shared RAM interface register diagnostics failed
Protocol-handler diagnostics failed
PC Card's programmable timer for the computer failed (set by the
microcode)
Cannot write to shared RAM (set by microcode)
Reading from shared RAM read-only area caused an incorrect error
indication (interrupt)
Writing into shared RAM read-only area did not cause an error indication
(interrupt)
Initialization timed out
Open completed successfully
Incorrect command code
Adapter open, should be closed
Required parameters not provided
Command cancelled, unrecoverable failure (see open error codes to isolate
problem)
Inadequate receive buffers
Incorrect MAC address
Incorrect adapter receive buffer length
Incorrect adapter transmit buffer length