Os/2 Installation; Os/2 Ndis 2 Device Driver Using Mpts - IBM Turbo 16/4 Token-Ring PC Card 2 User Manual

OS/2 Installation

OS/2 NDIS 2 Device Driver Using MPTS

If your OS/2 network operating system has not yet been installed on your computer,
install it now and follow its instructions for installing device drivers. If an OS/2
network operating system has previously been installed, follow the instructions here
for using MPTS to install device drivers.
10. Select Exit in the MPTS dialog box.
11. Select Exit on the Update CONFIG.SYS panel to update the CONFIG.SYS file.
12. Select OK when you get the message that the CONFIG.SYS has been
13. Select Exit on the Exiting MPTS panel.
14. Shut down OS/2 and restart your computer to let the changes take effect.
15. At system startup, check for the following conditions to determine whether the
26
Turbo 16/4 Token-Ring PC Card 2
1. Start MPTS by performing either of the following actions:
v From the OS/2 desktop, double-click the MPTS icon.
v From an OS/2 window, go into the IBMCOM subdirectory and enter mpts at
the OS/2 prompt.
2. Select OK on the MPTS logo panel.
3. Select Install. You will be prompted for the source of the .NIF file. Put the
CD-ROM in the drive. Enter x: where x is the letter of your CD-ROM drive.
Select OK once the Installation Complete message appears. You will return to
the main menu.
4. Select Configure in the MPTS dialog box.
5. On the Configure panel, make sure that LAN adapters and protocols is
preselected and then select Configure at the bottom of the panel.
6. In the Configuration panel, in the Network Adapters group box, select IBM
Turbo 16/4 Token-Ring PC Card 2 and select ADD.
Note: You can edit parameter settings for this PC Card. Highlight this adapter
in the Current Configuration list box and select Edit. When you have
finished with the parameter settings, select OK.
7. In the Protocols list box, select the protocols used by your network application.
Highlight each protocol and select ADD. If you are not sure which ones to use,
select IBM IEEE 802.2 and IBM OS/2 NetBIOS protocol drivers or ask your
network administrator.
The protocol drivers you have selected will appear under the adapter driver
name in the Current Configuration list box.
Note: You can edit parameter settings for the protocols. Highlight a protocol
and select Edit.
8. Select OK when you have finished selecting and editing protocols in the
Configuration panel.
9. Select Close on the Configure panel.
successfully updated.
Installation is now complete.
adapter is working correctly and whether installation has been completed
successfully:
v The device driver files loaded successfully. There are no error messages.
v You are able to log on and communicate with the network.