IBM Turbo 16/4 Token-Ring PC Card 2 User Manual page 29

10. Go to the Novell server directory and enter server at the DOS prompt to
restart the server.
11. Install the patches obtained earlier now. Make sure to select the v3.31 ODI
LAN Updates for Hardware if given the opportunity.
12. Installation is now complete.
Check for the following conditions to determine whether the adapter is working
correctly and whether installation is complete:
v The device driver files are loading successfully.
v There are no error messages.
If you experience problems, go to "Appendix B. Problem Determination" on
page 49.
For information concerning NetWare server error messages, see "Novell
NetWare Server Driver Parameters" on page 20.
Server Driver Installation in Existing NetWare 3.12 Server
If Novell NetWare is on your computer, perform the following steps to install the
adapter server device driver.
1. Create a diskette containing the extracted files from the NETWARE.EXE file on
the IBM Turbo 16/4 Token-Ring PC Card 2 CD-ROM.
2. Install the patches obtained earlier now. Make sure to select the v3.31 ODI
LAN Updates for Hardware if given the opportunity. Return to the server
console when the installation is complete.
3. Make sure that the diskette you created in step 1 has been inserted in drive A.
Enter the following commands at the server prompt. You might be prompted to
perform a file overwrite; it is OK to overwrite these files.
COPY A:\NOVELL\NETWARE\NBI31X.NLM C:\SERVER.312
COPY A:\NOVELL\NETWARE\MSM31X.NLM C:\SERVER.312
COPY A:\NOVELL\NETWARE\TOKENTSM.NLM C:\SERVER.312
COPY A:\NOVELL\NETWARE\IBMTOKEN.LAN C:\SERVER.312
COPY A:\NOVELL\NETWARE\IBMTOKEN.LDI C:\SERVER.312
Note: If you experience any problems after loading the Novell NLM files,
check the Novell Web site to ensure that you have the current version
of these files.
4. In the directory where Novell is installed on your hard disk, enter server at the
DOS prompt to start the server.
5. At the server console prompt, enter load install.
6. From the Installation Options menu, select System Options and press Enter.
7. Select Edit STARTUP.NCF File and press Enter. Add the following line to the
STARTUP.NCF file:
Set Minimum Packet Receive Buffers = 48
Note: Increase the minimum packet receive buffers by 48 for each additional
adapter that is installed.
8. Press Esc and then answer Yes to save changes to the STARTUP.NCF file.
9. Select Edit AUTOEXEC.NCF File and press Enter. Edit this file and, after the
IPX internal net statement, include the following statements. (Replace
C:\SERVER.312\ with the location of the NetWare server program.)
In a server environment, set the DataRate to M16 or M4, and clients to Auto.
The default is Auto.
Chapter 4. Software Installation
13