Precautions Regarding Installation - Sega TARGET BRAVO OPERATION GHOST Owner's Manual

2

PRECAUTIONS REGARDING INSTALLATION

• This product is an indoor game machine. Do not install it outside. Even indoors,
avoid installing in places mentioned below so as not to cause fire, electric
shock, injury and/or malfunction:
2
• Places subject to rain/water leakage or places subject to high humidity, in the
proximity of an indoor swimming pool and/or shower, etc
• Places subject to direct sunlight or places subject to high temperatures, in the
proximity of heating units, etc
• Places filled with inflammable gas or vicinity of highly inflammable/volatile
chemicals or hazardous matter
• Dusty places
• Sloped surfaces
• Places subject to any type of violent impact
• Vicinity of anti-disaster facilities such as fire exits and fire extinguishers
• Areas where the temperature exceeds the applicable temperature (ambient
temperature) range of 5 to 30 degrees centigrade
LIMITATIONS OF USAGE
• Be sure to check the Electrical Specifications. Ensure that this product
is compatible with the location's power supply, voltage, and frequency
requirements. A plate describing Electrical Specifications is attached to the
product. Noncompliance with the Electrical Specifications can cause a fire
and electric shock.
• This product requires a breaker and earth mechanism as part of the location
facilities. Using the product without these can cause a fire and electric shock.
• Ensure that the indoor wiring for the power supply is rated at 15 A or higher
(AC single phase 100 V ~ 120 V area), and 7 A or higher (AC 220 V ~ 240 V
area). Noncompliance with the Electrical Specifications can cause a fire and
electric shock.
• Be sure to use an independent power supply equipped with an earth leakage
breaker. Using a power supply without an earth leakage breaker can cause
an outbreak of fire if a power surge occurs.
• Putting many loads on one electrical outlet can cause generation of heat and
a fire resulting from overload.
• When using an extension cord, ensure that the cord is rated at 15 A or higher
(AC 100 V ~ 120 V area) and 7 A or higher (AC 220 V ~ 240 V area). Using a
cord rated lower than the specified rating can cause a fire and electric shock.
4