Precautions Regarding Installation - Sega bop it ARCADE Quick Start Manual

Table of Contents

PRECAUTIONS REGARDING INSTALLATION

• This product is an indoor game machine. Do not install it outside. Even indoors,

avoid installing in places mentioned below so as not to cause fire, electric

shock, injury and/or malfunction:

• Places subject to rain/water leakage or places subject to high humidity, in the

proximity of an indoor swimming pool and/or shower, etc

• Places subject to direct sunlight or places subject to high temperatures, in the

proximity of heating units, etc

• Places filled with inflammable gas or vicinity of highly inflammable/volatile

chemicals or hazardous matter

• In dusty places or locations prone to heavy dust accumulation

• On sloped or uneven surfaces

• Places subject to any type of violent impact

• Vicinity of anti-disaster facilities such as fire exits and fire extinguishers

• Areas where the temperature exceeds the applicable temperature (ambient

temperature) range of 5 to 30 degrees centigrade

2-1 LIMITATIONS OF USAGE

• Be sure to check the Electrical Specifications. Ensure that this product

is compatible with the location's power supply, voltage, and frequency

requirements. A plate describing Electrical Specifications is attached to the

product. Noncompliance with the Electrical Specifications can cause a fire

and electric shock

• This product requires a Breaker and Earth Mechanism as part of the location

facilities. Using the product without these can cause a fire and electric shock

• Ensure that the indoor wiring for the power supply is rated at 15 A or higher

(AC single phase 100 V ~ 120 V area), and 7 A or higher (AC 220 V ~ 240 V

area). Noncompliance with the Electrical Specifications can cause a fire and

electric shock

• Be sure to use an independent power supply equipped with an Earth Leakage

Breaker. Using a power supply without an Earth Leakage Breaker can cause

an outbreak of fire if a power surge occurs

• Putting many loads on one electrical outlet can cause generation of heat and

a fire resulting from overload

• When using an extension cord, ensure that the cord is rated at 15 A or higher

(AC 100 V ~ 120 V area) and 7 A or higher (AC 220 V ~ 240 V area). Using a

cord rated lower than the specified rating can cause a fire and electric shock

Table of Contents