Sega TARGET BRAVO OPERATION GHOST Owner's Manual page 15

Securing a safe area for operation as described in this manual will ensure
safe operation for players and observers.
SEGA shall not be held responsible for damage or compensation for damage
to a third party, resulting from the failure to observe this instruction.
OPERATION AREA (SINGLE CABINET)
• For safe operation, use and operate this product in an area measuring at least
1.94 m (76.3 in) in width and 1.91 m (75.1 in) in depth when the 42inch cabinet
is installed. Use and operate this product in an area measuring at least 2.28
m (89.7 in) in width and 1.93 m (75.9 in) in depth when the 55inch cabinet is
installed. SEGA shall not be held responsible for damage or compensation for
damage to a third party, resulting from the failure to observe this instruction.
• The ceiling where this product is installed must be at least 2.5 m (98.4 in) high
for the 42inch cabinet and at least 2.75 m (108.2 in) for the 55inch cabinet. If
the ceiling is too low, the heat emitted from the product may cause it to catch
on fire.
• Be sure to provide the sufficient space specified in this manual. Do not allow
objects to block the ventilation ports. This can cause generation of heat and a
fire.
• Put the cabinets close together so that people cannot get through or provide
enough space between them that people can go both ways without difficulty.
If the cabinets are installed carelessly, people may bump into each other or
the cabinets when passing between them or fall down. To prevent people
from walking between them, place them 0.15 m (5.9 in) apart.
• If the machine does not fit through the entryway to the installation location,
do not disassemble it without first consulting the instructions. Specific tools
and adjustment procedures are required to assemble and disassemble the
mechanical parts. Attempting to assemble or disassemble the machine
without consulting the instructions may result in accidents during assembly/
disassembly, electric shock, short circuits, and/or personal injury during
operation. If the machine still does not fit through the entryway after following
the procedures in this manual, contact your retailer or the office listed in this
manual.
• If the machine is still too large to fit through the entryway after following the
procedures listed in this manual, do not tip the machine on its side. Attempting
to transport the machine while it is tipped on its side may cause accidents. It
may also damage or warp parts of the machine, resulting in accidents during
operation.
2
5