Table of Contents
Advertisement
FX2N-64CL-M CC-Link/LT Master Block
11.1
System Startup Procedure
Install the FX
-64CL-M, remote I/O units and power adapter to the control panel and machine.
2N
Connect the FX
-64CL-M, remote I/O units and power adapter with the dedicated flat cables.
2N
Connect terminating resistors at the both ends of the trunk line.
Set the transmission speed, point mode, station No., etc. of the FX
using the DIP switches. (Set the FX
Check the following items before turning the power ON.
- Confirm the installation status of the FX
- Confirm the supply voltage for the power adapter.
- Confirm that the RUN/STOP switch for the main unit is set to STOP.
- Confirm that the same station No. is not used in two or more remote I/O units.
Executing CONFIG mode
Supply power to the power adapter before the main unit.
(Specify reserved stations and edit the detailed remote station information here if necessary.)
Terminating CONFIG mode
Turn OFF the power to the power adapter and main unit.
Set the DIP switch in the FX
Supply power to the power adapter before the main unit.
Confirming the operation based upon LEDs
FX
-64CL-M
2N
- Data link is normal: L RUN is lit.
- Data link is abnormal: L ERR. is lit or flickering.
- Setting is abnormal: The ERR. is lit.
Remote I/O unit
- Confirm remote station connection by checking buffer memory [BFM #0 (0h) to
#3 (3h)] in the FX
-64CL-M.
2N
- Confirm device operation using peripheral equipment for the PLC (with regard to monitorly and
forcing inputs + outputs ON and OFF).
Start
-64CL-M to the CONFIG mode.)
2N
-64CL-M, remote I/O units and power adapter.
2N
-64CL-M to the ONLINE mode.
2N
Write a control program to the main unit.
Operate the system.
End
-64CL-M and remote I/O units
2N
Program Example 11
Refer to
Section 5.
Refer to
Section 6.
Refer to
Sections 1
and 7.
Refer to
Section 8.
Refer to
Sections 10
and 12.
Refer to
Section 11.
11-3
Advertisement
Table of Contents
