Danfoss VLT AQUA Drive FC 202 Operating Manual page 4

Contents
5.9 Control Wiring
6 Pre-start Check List
7 Commissioning
7.1 Applying Power
7.2 Programming the Drive
7.3 Testing Before System Start-up
7.4 System Start-up
7.5 Parameter Setting
8 Wiring Configuration Examples
8.1 Wiring Configurations for Automatic Motor Adaptation (AMA)
8.2 Wiring Configurations for Analog Speed Reference
8.3 Wiring Configurations for Start/Stop
8.4 Wiring Configurations for an External Alarm Reset
8.5 Wiring Configuration for Speed Reference Using a Manual Potentiometer
8.6 Wiring Configuration for Speed Up/Speed Down
8.7 Wiring Configurations for RS485 Network Connection
8.8 Wiring Configuration for a Motor Thermistor
8.9 Wiring Configuration for a Relay Set-up with Smart Logic Control
8.10 Wiring Configuration for a Submersible Pump
8.11 Wiring Configuration for a Cascade Controller
8.12 Wiring Configuration for a Fixed Variable Speed Pump
8.13 Wiring Configuration for Lead Pump Alternation
9 Maintenance, Diagnostics, and Troubleshooting
9.1 Maintenance and Service
9.2 Heat Sink Access Panel
9.3 Status Messages
9.4 Warning and Alarm Types
9.5 List of Warnings and Alarms
9.6 Troubleshooting
10 Specifications
10.1 Electrical Data
10.2 Mains Supply
10.3 Motor Output and Torque Data
10.4 Ambient Conditions
10.5 Cable Specifications
10.6 Control Input/Output and Control Data
10.7 Fuses and Circuit Breakers
2
VLT® AQUA Drive FC 202
Danfoss A/S © 09/2018 All rights reserved.
63
68
69
69
69
71
71
72
73
73
73
74
75
76
76
76
77
77
78
80
81
81
82
82
82
83
85
86
96
98
98
106
106
106
107
107
110
MG21A502