Table of Contents
Advertisement
Section 6: Troubleshooting and
A. SOLVING PRINT ALIGNMENT PROBLEMS
Image is Vertically Offset
The LX910e decides where to start printing by detecting the start of
die-cut label, detecting a black mark on the back of the label or
detecting a through-hole that corresponds to the start of the label.
The following items can cause the label sensor to improperly detect
the start of a label:
1. Top of Form (TOF). TOF stands for Top of Form and this
setting allows you to fine tune the alignment of your
printing on your label stock. This will be factory
calibrated. If fine tuning is needed, increase this setting to move
the image down on the label; decrease this setting to move the
image up on the label. The unit of measure is 0.1mm. This
setting is found on the Alignment Tab of the PrintHub and Print
Utility (Mac).
Maintenance
Troubleshooting and Maintenance
57
Advertisement
Table of Contents
