Table of Contents
Advertisement
Continuous. (Sensor off.) If you have continuous stock with no
die-cut, reflective mark or holes, set the Sensor Type to
Continuous. This will turn off the stock sensor. In this mode
there is no way to set the print starting position. The printer
will simply start printing the first label and print each
subsequent label immediately after the previous. To produce a
gap between prints simply add the desired amount of white
space to the end of the label being printed.
D. SET THE OUTPUT MODE
Use the Present/Cut Mode to adjust how the printer presents
labels after they are printed or if/when they are cut after
printing. There are different options available which change if
the Cutter is enabled or disabled. If the Cutter is disabled the
label present options will be available. If the Cutter is enabled
the present options are are no longer available but cut options
become available. Read more in section 2E.
Cut Options (Check Cutter Enabled):
Cut after no activity. This setting will cut at the end of a print
job if the printer does not receive another print job within one
second of the last print job in the queue. You can usethis
feature to cut at the end of multi-copy job, multi-page job or
multiple individual jobs in the queue.
Cut after button press. This setting will cut after you press the
Load/Feed button on the printer. This can be used after one
label or an entire job. This feature is useful if you will not be
Printing from a Mac
44
Advertisement
Table of Contents
