Creating A Full Bleed Print - Primera label LX910e User Manual

•
Top of Form (TOF). This value moves the print start
position up or down on the label. Add to the current value to
move the printed label down or toward the printer. Subtract
from the current value to move the printed label up or away
from the printer. The value is automatically saved as soon as
F. CREATING A FULL BLEED PRINT
1. To create a label that completely fills the space with no white
margins, adjust these settings in the status monitor and printing
application (BarTender).
Page Size. Increase the page size width by .03 inches (1mm).
Increase the height by .03 inches (1mm). If you are using
BarTender, simply change the size under the File Menu - Page
Setup. If you are using other graphics programs you will need
to change the page size in the application and in the printer
driver preferences.
Left Margin Offset. You must decrease the left margin offset to
center the over bleed on the label. If you over bleed by .03" you
will need to decrease the Left Margin Offset by 0.4mm. This
will center the page size increase so there is a .03 inch over
bleed on both left and right sides. Some additional adjustment
may be necessary if the label was not perfectly aligned to begin
with. See Section 4E.
Printing from a PC
34
you set it.
You may have to make several
adjustments to one or more of these
values. After each adjustment you
can click the Test button to print a
small test pattern on the label. This
will help you find the proper
alignment value.