Table of Contents
Advertisement
The sensor can only be moved a maximum of 2 inches
from the left side of the printable area. This means that the
maximum diameter circular label that can be printed is 4
inches. For circular labels larger than 4 inches in diameter, you
must have a black mark printed on the back of the label stock.
This means that you must change the Stock Sensor Mode to
Reflective. The printer will now look for the black mark
representing the beginning of the next label instead of the
die-cut. For more information on changing the Stock Sensor
Mode see Section 2D.
1/2"
Center
of Hole
Through-Hole Labels
Set Sensor Bar to 28.4 mm (1 1/8") for 50.8 mm (2") circular label (3 mm (1/8")
Through-Hole Labels
If you are using card stock or label stock that has a hole punch
or a notch to identify a transition from backing to label, you
can adjust the Stock Sensor to position it over the identifying
mark.
D. SET THE STOCK SENSOR MODE
The stock sensor mode refers to the method the printer will use
to detect the print starting position for each label. To adjust the
stock sensor mode, open the PrintHub. In most cases you will
NOT need to change this setting. By default it is set to sense
standard die-cut labels. It is only necessary to change this
setting if you are using clear labels or any label with a black
sensing mark on the back.
liner edge gap).
1 1/8"
Center
of Circle
Circular Labels
Label Stock
13
Advertisement
Table of Contents
