Table of Contents
Advertisement
C. ADJUSTING THE GAP SENSOR POSITION
If you are using label stock other than standard square /
rectangular die-cut labels such as circular die-cut labels or
through-hole stock use the instructions below to adjust the
position of the label stock gap sensor. The sensor can be
adjusted using the slide bar on the inside of the printer. Below
the slide bar is a measurement which represents the distance
between the edge of the label stock and the sensor. Measure
the distance from the edge of the label stock to the correct
position on the stock. Set the sensor so the side of the slide bar
lines up to this measurement. See dashed line in the
illustration below.
Important Note: You must adjust the stock sensor before loading
nonstandard label stock.
in.
mm
Circular Labels
If you are using Circular Labels you must adjust the stock
sensor to correspond with the very top of the label where the
circles are closest together. If the sensor is too far to the right or
the left the printer will still sense the label but the image may
be offset downward because the printer will start printing at
the wrong position. If you are using stock that has multiple
labels across make sure the sensor corresponds to a place on
the stock that has a label and not a vertical gap.
Label Stock
12
2.0
1.5
1.0
50.8
38.1
25.4
Label Stock Sensor Slide
0.5
12.7
Advertisement
Table of Contents
