Table of Contents
Advertisement
Three items can be adjusted here:
*
Tear off Position. This value adjusts the position of the last
label printed after it has been presented for tear off. This
only applies if the output mode is set to "Present." Add to
the current value to move the tear point closer to the
printer. Subtract from the current value to move the tear
point away from the printer. After adjusting the value click
the Set Offsets button to send the value to the printer.
*
Left Margin Offset. This value moves the printed label left
or right. Add to the current value to move the printed label
to the right. Subtract from the current value to move the
printed label to the left. After adjusting the value, click the
Set Offsets button to send the value to the printer.
Note:
Before adjusting this value make sure the label stock is properly
loaded so that there is no gap between the edge of the liner and the
fixed throat guide. Any gap at this point will greatly affect the Left
Margin Offset value needed to align the label. Also, if you adjust the
value with improperly loaded label stock you will have to adjust it
again if you load the label stock correctly the next time.
*
Top of Form (TOF). This value moves the print start
position up or down on the label. Add to the current value
to move the printed label down or toward the printer.
Subtract from the current value to move the printed label
up or away from the printer. After adjusting the value click
the Set Offsets button to send the value to the printer.
Printing from a Mac
42
You may have to make several
adjustments to one or more of these
values. After each adjustment you can
click the Test Offsets button to print a
small test pattern on the label. This will
help you find the proper alignment
value.
Advertisement
Table of Contents
