Table of Contents
Advertisement
1. Connect the printer via USB and turn on the power. The
2. Go to Start - Programs - Primera Technology - Primera
3. Click on the Label Feed (3rd tab from left).
4. Select the Stock Sensor Mode by clicking on the graphic
5. Load the label stock after you have set the sensor mode.
There are three sensor modes:
Die-Cut (Default). If you are using standard die-cut labels that
look similar to the graphic, use this setting regardless of the
size of the label. Also, use this setting for Through-hole label
material where a hole is punched through each label or a notch
is cut in the side.
Reflective. Use Reflective for label material where a black
pre-printed line (black mark) on the back of the label stock
indicates the break between labels. Black marks are required
on clear label stock rolls, or label where the label waste matrix
(waste) is left on the liner. Black marks can also be used for
irregular shaped labels, circles larger than 4 inches or on any
stock where the print starting position can not be sensed using
the label itself.
Label Stock
14
Stock Sensor Mode setting is stored in the printer's internal
memory so you will not be able to access it unless the
printer is turned on and properly communicating with the
computer.
PrintHub.
that most closely corresponds to the stock you intend to
install.
Advertisement
Table of Contents
