Table of Contents
Advertisement
3. Remove any shipping tape from your label stock roll to
4. Place your roll of label stock on the Roll Arm and push it
Roll Stop
Roll Guide
Roll Arm
5. Flip up the Roll Guide and slide it inward until it touches
Important Note: Be aware that some label stock may have a core that
is slightly too large for the roll or the labels may have wrapped
unevenly causing some to stick out beyond the edge of the core.
Both of these issues can cause feeding problems.
Label Stock
10
ensure that it can unroll freely, making certain that no
adhesive portion is exposed. It is important to note that
any exposed adhesive surface can attach itself to the inner
workings of the print mechanism and cause a media jam.
inward until it touches the Roll Stop.
the label stock. The Roll Guide will automatically pull back
slightly to the correct position. There should be
approximately a 1mm gap between the Roll Guide and the
roll.
Do Not Pinch!
Advertisement
Table of Contents
