Table of Contents
Advertisement
Adjust print alignment using the PrintHub. Go to the Print
Alignment Tab (second tab).
Important! Before adjusting any values, print the Test print to see how close
you are to alignment. The on screen graphic is the same as the print
which makes it easier to adjust these values.
Three items can be adjusted here:
•
Tear off/Cut Position. This value adjusts the position of
the last label printed after it has been presented for tear off
or for cutting. This only applies if the output mode is set
to "Present the label." Add to the current value to move
the tear point closer to the printer. Subtract from the
current value to move the tear point away from the printer.
The value is automatically saved as soon as you set it.
•
Left Margin Offset. This value moves the printed label left
or right. Add to the current value to move the printed
label to the right. Subtract from the current value to move
the printed label to the left.
Note:
Before adjusting this value make sure the label stock is properly load-
ed so that there is no gap between the edge of the liner and the fixed
throat guide. Any gap at this point will greatly affect the Left margin
offset value needed to align the label. Also, if you adjust the value
with improperly loaded label stock you will have to adjust it again if
you load the label stock correctly the next time.
Printing from a PC
33
Advertisement
Table of Contents
