Table of Contents
Advertisement
C. SET THE STOCK SENSOR MODE
The stock sensor mode refers to the method the printer will use
to detect the print starting position for each label. To access the
Stock Sensor Mode, click on the Alignment button (3. tab), then
select Stock Sensor Mode. In most cases you will not need to
change this setting. Read more in section 2D.
Important Note: Set the Stock Sensor Mode BEFORE loading label stock!
You must also set the Stock Sensor Position (Section 2C) so that the
sensor is sensing the correct point on the label stock.
Die Cut (Default). If you are using standard die-cut labels that
look similar to the graphic use this setting regardless of the size
of the label. Also, use this setting for through-hole label
material where a hole is punched through each label or a notch
is cut on the side.
Reflective. Use Reflective for label material where a black pre-
printed line (black mark) on the back of the label stock
indicates the break between labels. Black marks are required on
clear label stock rolls, or labels where the label waste matrix
(waste) is left on the liner. Black marks can also be used for
irregular shaped labels, circles larger than 4.6 inches or on any
stock where the print starting position can not be sensed using
the label itself.
Printing from a Mac
43
Advertisement
Table of Contents
