Set The Present/Cut Mode - Primera label LX910e User Manual

Continuous. (Sensor off) If you have continuous stock with no
die-cut, reflective mark or holes, set the sensor type to
Continuous. This will turn off the stock sensor. In this mode
there is no way to set the print starting position. The printer
will simply start printing the first label and print each
subsequent label immediately after that previous one. To
produce a gap between prints simply add the desired amount
of white space to the end of the label being printed.
Important Note: You must also set the Stock Sensor Position (Section 2C)
so that the sensor is sensing the correct point on the label stock.
E: SET THE PRESENT/CUT MODE
Use the Present/Cut Mode to adjust how the printer presents
labels after they are printed or if/when they are cut after
printing. To adjust the Present/Cut Mode, open the PrintHub
program.
1. Connect the printer via USB and turn on the power. The
Output/Cut Mode Setting is stored on the printer main
board so you will not be able to access it unless the printer
is turned on and properly communicating with the com-
puter.
2. Go to Start - Programs - Primera Technology - Primera
PrintHub.
3. Click on the Label Feed Tab.
4. Click on the Output/Cut Mode button.
There are different options available which change if the Cutter
is enabled or disabled. If the Cutter is disabled the label
present options will be available. If the Cutter is enabled the
present options are are no longer available but cut options
become available.
Label Stock
15