Jumper Settings - Supero SUPERSERVER 5017K-N6 User Manual

S S
UPER ERVER 5017K-N6 User's Manual
5-9

Jumper Settings

Explanation of Jumpers
To modify the operation of the mother-
board, jumpers can be used to choose
between optional settings. Jumpers
create shorts between two pins to
change the function of the connector.
Pin 1 is identifi ed with a square solder
pad on the printed circuit board. See
the motherboard layout pages for
jumper locations.
Note: On a two-pin jumper, "Closed"
means the jumper is on both pins and
"Open" means the jumper is either on
only one pin or completely removed.
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To clear CMOS,
1. First power down the system and unplug the power cord(s).
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
PCI-E Slot Select
Jumper JPSLOT1 allows the user to
select which of the slots to enable,
Slot7 or Slot6.
Note: This function is designed for
Supermicro SC504/505 chassis,
which uses Slot7 (default).
Connector
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
5-14
3 2
Pins
Jumper
3 2
Setting
SLOT6/7 Select
Defi nition
Slot 7 (Default)
Slot 6
1
1