Supero SUPERSERVER 5017K-N6 User Manual page 59

Watch Dog Reset
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when a
software application hangs. Close pins
1~2 to reset the system if an applica-
tion hangs. Close pins 2~3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
Manufacture Mode
Close pins 2 and 3 of JPME2 to bypass
SPI flash security and force the system
to operate in the Manufacture Mode,
allowing the user to flash the system
firmware from a host server for system
setting modifications. See the table on
the right for jumper settings.
SMB (I2C) Bus to PCI Slots
Jumpers JI2C1 and JI2C2 allow you to
connect the System Management Bus
(SMB) to PCI-E and PCI slots. The de-
fault setting is Disabled. See the table
on the right for jumper settings.
Front Panel LED Select
Jumper JPF1 allows the user to confi gure
the front panel LAN LED to display status
indicators for either normal LAN traffi c, or
Bypass LAN.
Front Panel RST Button Select
Jumper JPF2 allows the user to
confi gure the front panel reset button to
either send a Non-Maskable Interrupt
request or a hardware reset to the
system.
Chapter 5: Advanced Motherboard Setup
Jumper Setting
Pins 1-2
Pins 2-3
Open
Manufacture Mode (JPME2)
Pin#
Pins 1-2
Pins 2-3
Jumper
On
Off
Front Panel LED Select
Jumper Setting
Pins 1-2
Pins 2-3
Front Panel RST Select
Jumper Setting
Pins 1-2
Pins 2-3
5-15
Watch Dog
Jumper Settings
Defi nition
Reset
(default)
NMI
Disabled
Jumper Settings
Defi nition
Normal (Default)
Manufacture Mode
I2C to PCI-Slots
Jumper Settings
Defi nition
Enabled
Disabled (Default)
Jumper Settings
Defi nition
Bypass LAN LED
Normal (Default)
Jumper Settings
Defi nition
FR/NMI
Normal (Default)