Supero SUPERSERVER 5017K-N6 User Manual page 69

Installing 2.5" Hard Drives
Several different confi gurations of 2.5" hard drives may be installed in the system.
Review the supported confi guration options on page 6-6.
1. Power down the server, disconnect the power cord from the power supply and
remove the cover.
2. Install 2.5" hard drive(s) into the hard drive bracket(s) and secure them to the
bracket with the screws provided. (See page 6-6 for supported confi guration
options.)
3. Place the hard drive and bracket into the chassis as illustrated in Figure 6-3.
If up to two 2.5" hard drives are desired, rotate the hard drive brackets ninety
degrees and place them side by side before attaching them to the chassis.
4. Secure the hard drive bracket(s) to the chassis fl oor by inserting the screws
up through the underside of the chassis.
5. Expansion cards must be installed after installing the 2.5" hard drives.
6. Connect the hard drive wiring, reinstall the chassis cover and power cord,
then power up the server.
Note: Bracket part number is MCP-220-00051-0N (1x 2.5" HDD) or MCP-220-
00044-0N (2x 2.5" HDD).
Note: The drive bracket may cause add-on card interference. Please check card
dimensions before choosing the drive bracket type.
Chapter 6: Advanced Chassis Setup
6-5