S
S
UPER
ERVER 5017K-N6 User's Manual
SATA Confi guration
When this submenu is selected, the AMI BIOS automatically detects the presence
of the SATA Devices and displays the following items:
•
SATA Port0
•
SATA Port1
SATA Mode
This item selects the mode for the installed SATA drives. The options are IDE Mode,
and AHCI ModeI, and Disabled.
If the item above -SATA Mode Selection is set to AHCI, the following items
are displayed:
Serial ATA Port 0~ Port 1
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Staggered Spin Up
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization sequence to the device. The options are Enabled and Disabled.
Port 0 ~ Port 1 Hot Plug
This feature designates the port specifi ed for hot plugging. Set this item to En-
abled for hot-plugging support, which will allow the user to replace a SATA disk
drive without shutting down the system. The options are Enabled and Disabled.
PCIe/PCI/PnP Confi guration
This feature allows the user to set the PCI/PnP confi gurations for the following items:
Above 4G Decoding
Select Enabled for 64-bit devices to be decoded above the 4GB address space
If 64bit PCI decoding is supported by the system. The options are Disabled and
Enabled.
7-12