Jumper Settings; Explanation Of Jumpers - Supero 2122TG-HIBQRF User Manual

A+ SERVER 2122TG-HIBQRF/HTRF USER'S MANUAL
5-9

Jumper Settings

Explanation of Jumpers

To modify the operation of the motherboard,
jumpers can be used to choose between
optional settings. Jumpers create shorts
between two pins to change the function
of the connector. Pin 1 is identified with
a square solder pad on the printed circuit
board. See the diagram at right for an
example of jumping pins 1 and 2. Refer
to the motherboard layout page for jumper
locations.
Note: On two-pin jumpers, "Closed" means
the jumper is on and "Open" means the
jumper is off the pins.
CMOS Clear
JBT1 is used to clear CMOS, which will also clear any passwords. Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To Clear CMOS
1. First power down the system and unplug the power cord(s).
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
InfiniBand Enable/Disable
(2122TG-HIBQRF only)
The JIB1 jumper allows you to enable or
disable the InfiniBand connector. The default
position is on pins 1 and 2 to enable the
InfiniBand connector. See the table on the
right for jumper settings.
InfiniBand Connector
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
5-16
3 2
Connector
Pins
Jumper
3 2
Setting
JBT1 contact pads
Enable/Disable
Definition
Enabled
Disabled
1
1