Additional Information - Patton SmartNode SN4170 User Manual

SmartNode 4170 User Manual
can use it to speed up configuring the SmartNode. Simply download the configuration note that matches your
application to your PC. Adapt the configuration as described in the configuration note to your network
(remember to modify the IP address) and copy the modified configuration to a TFTP server. The SmartNode
can now load its configuration from this server.
If your application is unique and not covered by any of Patton's configura-
Note
tion templates, you can manually configure the SmartNode instead of load-
ing a configuration file template. In that case, refer to the SmartNode Series
Trinity Command Line Reference Guide for information on configuring the
SmartNode device.
In this example we assume the TFTP server on the host with the IP address 172.16.1.11 and the configuration
named SN.cfg in the root directory of the TFTP server.
172.16.1.99(if-ip)[WAN]#copy tftp://172.16.1.11/sn.cfg startup-config
172.16.1.99(if-ip)[WAN]#
After the SmartNode has been rebooted the new startup configuration will be activated.
172.16.1.99(if-ip)[WAN]#reload
Press 'yes' to restart, 'no' to cancel :yes
The system is going down NOW

Additional Information

For detailed information about configuring and operating guidance, set up procedures, and troubleshooting,
refer to the Trinity Command Line Reference Guide available online at www.patton.com/manuals.

Additional Information

4 • Initial Configuration
35