Patton SmartNode SN4170 User Manual page 17

SmartNode 4170 User Manual
Port
PRI 0/0 - PRI 0/1
Console
12V DC, 1A
Reset
SmartNode SN4170 Overview
Table 2. Rear panel ports (Continued)
RJ-45 connector providing E1 or T1 PRI interface, meeting
all requirements of ITU-T recommendations for G.703. Use a shielded E1
or T1 interface cable for 120 Ohm balanced connections to connect the
SmartNode with an NT or TE.
Appendix C
Note Refer to
Appendix D
on page 50 for pin-outs
Used for service and maintenance, the console port (see
page 16) an RS-232 RJ-45 connector, connects the product to a serial
terminal such as a PC or ASCII Terminal (also called a dumb terminal).
Configuration settings:
•
19200 bps
•
8 bits, no parity
•
1 stop bit
•
flow control off
Electricity supply socket. (see
The reset button has several functions, as described in appendix F,
"Reset Button Functions"
Description
on page 46 for cabling and
figure 2
on page 16)
on page 55.
1 • General Information
figure 2
on
17