Installing The Patient Pole - Days Casa Med Classic FS Operating Manual

NURSING BEDS
Fixing the bed rail at the foot end:
Press the plastic caps (1) onto the bed
rail (observe drill hole position).
NOTE
Before pushing on, check to see that
the spring is located in the cap.
Die Guide the pegs (2) on the sliders into
the drill holes in the cap and bed rails.
When doing this, the pointed side of the
guide rail must face upwards (see
sketch).
Press bottom fastening knob (3),
Push the slider (4) into the guide groove
on the foot front face and
engage in top locking device.
Install the second bed rail in the same
manner as the first.

7.14 Installing the patient pole

Insert the patient pole (1) in the
attachment (2) fixed to the bedframe at the
required bed side.
NOTE:
The guide groove at the end of the
patient pole tube (1) must be
located over the pins in the
attachment (2).
Push the handgrip strap loop (3) onto
the patient pole tube.
Setting up the nursing bed
Casa Med Classic FS
Bed rails on foot end
Installing the patient
pole
Issued: 25.07.2007
31