Filling The Solution Tank - Mytee Speedster LTD3 Instructions Manual

SPEEDSTER® LTD3
VACUUM AND SOLUTION HOSE CONNECTIONS
Attach female end of a solution hose to a wand or tool and the
male end to the LTD's QD. Then connect a vacuum hose to a
wand and the 2" male Cuff-Lynx™ hose port. (If using the optional
de-foamer, install the kit onto the vacuum port according to the
instructions that come with the de-foamer kit.)
PRIME VALVE & PRESSURE REGULATOR
Prime the pump by having the Prime Valve parallel with its pipe
and turn it clock-wise to run the pump. Turning the Pressure Regu-
lator to its left will decrease water pressure and turning to the right
will increase water pressure.
*Please refer to the Pressure Gauge to monitor your water pressure.
SWITCH PLATE
Vac 1 Vac 2 Pump Pump
To use vacuum, turn on Vac 1 and Vac 2. To use pump, turn on
Pump. To use pump-out, turn on Pump-Out switch. To use Heater,
turn on Heater. Release tool trigger. Wait 8 – 10 minutes for unit
to pre-heat. Once heated, re-key upholstery tool until hot water
begins flowing. Once hot water is flowing, release trigger and
pre-heat an additional 4 – 5 minutes.

FILLING THE SOLUTION TANK

You can lift the lid to manually fill the tank or follow the "Operating
Instructions" for auto-fill use. IMPORTANT: Before refilling solu-
tion tank, make sure the recovery tank is empty.
7
Heater
out