About Using Easyone Air To Process Orders; Overview Of The Integration Process - NDD EasyOne Air Operator's Manual

Connectivity and data exchange
6.2.3

About using EasyOne Air to process orders

6.2.4

Overview of the integration process

Operator's Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
The direct-start workflow
Your EMR system is either connected to EasyOne Connect or EasyOne Pro/LAB
over the network, or your EMR system is installed on the same PC as
EasyOne Connect.
Either way, your EMR system can interact and launch EasyOne Connect or
EasyOne Pro/LAB directly. EasyOne Connect or EasyOne Pro/LAB act as an
external device to your EMR system.
This workflow is called direct-start workflow because you initiate a spirometry
test from your EMR system.
 Sending individual test results to your EMR system, 50
When you synchronize EasyOne Air with EasyOne Connect, orders from your
EMR system are also synchronized with EasyOne Air.
On EasyOne Air, you can select orders from your EMR system in the orders
menu.
Please contact the ndd Servicing Department to start an integration project.
The integration process consists of the following steps:
1 Defining an interface based on clinical requirements, IT requirements, and
security requirements
2 Implementing a configuration in close cooperation with your staff
3 Verifying the implemented configuration
NOTICE
CONNECTION FAILURE
Updates to the EMR system can potentially influence the connection.
When you update the EMR system, you must check the correctness of the
transferred data to connected systems.
 Operator's Manual of your EMR system
SDK – ndd EMR plug-in Software Developer Guide
Contact information, 4
50
46/144