Table of Contents
Advertisement
Configuration
11.2.4.2
Utilities > Configuration > Test > Predicted
Operator's Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
Curve Overlay
To select which trials are to be displayed in the flow-volume curve and the
volume-time curve on the test result screens, choose the corresponding
check box.
By default,
+ Session Best
Test Procedure
If you deselect
Manual Test
By default,
Manual Test Stop
General
To display on the test result screens a comparison of the best trial and the
predicted values as percentage values also for the post, choose
predicted column for post
To display ratio parameters (for example FEV
example 78%) instead of a decimal ratio (for example 0.78), choose
ratio parameter in
%.
By default, both check boxes are deselected.
To set the maximum number of trials for forced and slow spirometry enter a
value between 1 and 99 in the text field
The default value is 99. The text fields
EasyOne Connect PC software, but to the firmware of EasyOne Pro/LAB only. A
change of the values
DLCO
PC software.
Predicted normal values setting
Predicted normal values are based on the latest scientific publications.
Therefore, the predicted normal values are subject to change. These changes
are delivered to you via software updates.
Updated information is published in an Application Note on the ndd website.
Application Note Reference Predicted Normal Values
Application Notes for further information, 3
List of bibliographic references, 132
and
+ Pre Best
are selected.
Stop, you enable automatic test stop.
is selected.
tests.
/FVC) as a percentage (for
1
Max Number of Trials
DLCO
and
MBW
and
MBW
is without effect for the EasyOne Connect
Show %
Show
Forced/Slow.
do not apply to the
108/144
117
Advertisement
Table of Contents
