DataCard CR500 Installation And Administrator's Manual page 74

Option
DPCL2Secure
DPCLSecure
Remake
RemakeMethod
RetrieveDataTimeout
SmartcardForceProtocol
SmartcardForceShareMode
60
Description
Enable or disable DPCL2 command access to the printer through the
secure port.
Default: Enabled
Enable or disable DPCL command access to the printer through the
secure port.
Default: Enabled
Enable or disable card remakes. If Remake is enabled and a print
request fails, the print request is tried again with a new card. A card
is retried only once.
Default: Enabled
Select the card remake method. Choices are PreserveOrder (reprint
in queue order) or ConserveSupplies (reprint out of queue order).
This setting is ignored if Remake is set to Disabled.
Default: ConserveSupplies
Specify the time period during which card data can be retrieved. You
can specify from 0 to 120 seconds. If the current value is 0, data is
not retrieved.
The smart card reader normally auto-detects the protocol to use to
communicate with the smart card chip. However, if a smart card
application changes protocols, the smart card reader may continue
to try to communicate using the previous protocol. Use this setting
to override auto-detection of the communication protocol, if
necessary. You can select from the following options:
Disabled: No override, the smart card reader auto-detects the

protocol to use.
T0: Force the protocol to T=0 (asynchronous half-duplex byte

transmission).
T1: Force the protocol to T=1 (asynchronous half-duplex block

transmission protocol).
Default: Disabled
Select from the following options:
Disabled

Exclusive

Shared

Direct

Default: Direct
Using Printer Manager