Kentix AlarmManager-BASIC User Manual page 89

Here you will find additional settings for the selected DoorLock:
Default teach-in DoorLock
When learning new RFID-Tokens for the users this device is always displayed at first in the selection.
Name
Enter a name for the DoorLock-device. Typically this corresponds to the installation place.
Couple Time
Select the desired time (3 / 6 / 12 seconds), for which a device shall stay engaged after a valid booking.
Booking switches Alarmzone
If desired, an arm-/disarm-switching of a Kentix alarm system can be triggered by a booking.
The AlarmManager communication has to be activated for this in the „Configuration" section.
Choose the desired Alarmzone here. If no Alarmzone is displayed, press the refresh-button to update the zone
selection.
Time control
Kentix online-cylinder or door lever can be configured to stay permanently engaged. The door can then be
opened without a booking at the RFID reader.
For this operating mode a time profile can be chosen here which determines the times to which the door can be
opened without additional authorization.
NOTE!
To enable the permanent coupling, a valid booking has to be performed within the selected time profile.
Without a booking the door remains closed.
Switch output on booking
The Kentix AccessPoint has 2 Relais-Outputs. These can by switched/activated by a booking (e.g. in
combination with a wall reader), to control external components (motor locks, barriers).
You can choose between two switching outputs at the AccessPoint.
Assigned Network Camera
Configured network cameras can be assigned to a door. Each time a RFID card is read at this door, an SD card
recording of several images is triggered and linked to the logbook entry.
The settings for network cameras can be found in „Configuration" -> „Network cameras".
Access profiles
In the settings of a DoorLock-device a direct assignment to one or multiple access profiles can be made, if
profiles have already been configured.
Page 89 (06-2017, subject to change) kentix.com