Table of Contents
Advertisement
5.8.9. Control
Switch alarm output 2
Changes the state of the 2nd alarm output (output 1 is controlled by the alarming) for the entered switching
time. If „0" is entered for the time, the output stays permanently switched on.
For switching, the user password has to be entered. Default state of the output is 0.
PDU 1/2 - Switch outputs
Switches output 1/2 of the PDU on or off. If the value for the switching time is „0" or empty, the PDU is switched
permanently. For switching, the user password has to be entered.
WARNING!
Deactivating an output stops the power supply to all connected end-devices of the PDU.
Page
46
(06-2017, subject to change)
kentix.com
Advertisement
Table of Contents
