Table of Contents
Advertisement
5.11.Perform software update on MultiSensor-LAN / -RACK
The MultiSensor-LAN / -RACK offers the possibility to actualize its software via the integrated web server. Actual
software updates are available in the software section on www.kentix.com.
To check the actual installed software version, open the sensor's web server and open the system information in
the „System" section.
To perform an update follow these steps:
Nr
Unpack the update file (ZIP) into an new folder on your PC. The unpacked file has the name „image.bin" and
1
must not be renamed.
2
Connect to the MultiSensor using a web browser. Login to the device and click on „System".
Before the update, there is the possibility to perform a backup of the configuration.
This backup can also be used to be restored to another MultiSensor-LAN or -RACK.
3
For the update the backup is not mandatory, the configured settings will not be deleted during the update
process. We only recommend to create a backup in case of an error.
4
After the backup, please click on the button „Start update" in the section „Firmware update".
5
The device will restart and then display an update dialogue.
6
Choose the unpacked firmware file „image.bin" and then again select „Start update".
After about 1-2 minutes the MultiSensor automatically restarts.
7
IMPORTANT! During the update process, the power supply must not be interrupted.
8
The MultiSensor is now available again and you can check the software version in the „System" section.
Page
50
Step
(06-2017, subject to change)
kentix.com
Advertisement
Table of Contents
