Wiring Diagrams - Sargent SE LP10 7000 Series Installation Instructions Manual

SE LP10 7000 Series Multi Point Lock

Wiring Diagrams

5
1-Black 2-Red 3-White
12VDC WIEGAND
(Reader)
NEG POS DATA_1
*Diagrams on following pages
The SE LP10 reader can be configured for various modes of LED and beeper operation. HID programming
cards are supported to configure the behavior for LED and beeper activity. Call 1-800-810-WIRE (9473) for
details. Along with the programming cards, the TAMPER wire can be connected within the panel and the
lock in order to enable some of the listed features.
Default Operation Mode:
• Red LED 'ON' when powered.
• Presenting a 13.56 MHz or 125 kHz credential causes LED to briefly
turn green and then return to red state.
• Presenting a FIPS 201 PIV credential causes LED to turn amber as
credential is authenticated. Reader emits a short beep when
credential is successfully read. Reference *Diagram #1.
Optional Operation Mode:
Connect selected TAMPER wire from reader to ElectroLynx cable pin 8.
Note: For fire rated doors solder sleeve (P/N 52-1373) to be applied to
desired lead 2.5" from base of reader. See diagram for application.
Connect Yellow TAMPER wire from ElectroLynx cable to desired EAC panel
control line.
As appropriate, use configuration card to activate desired mode on reader.
Note: When Yellow TAMPER wire is tied directly into EAC panel relay, no AC signals should be applied on wire or door reader performance will be impacted.
Wire Gauge Charts
Total
One-Way
Length of
Wire Run (ft) 1/4A 1/2A 3/4A
100 20 18 16
150 18 16 14
200 16 14 12
250 16 14 12
300 16 12 12
400 14 12 10
500 14 10 10
750 12 10 —
1,000 10 — —
1,500 10 — —
8 PIN CONNECTOR
4-Green 5-Orange 6-Blue
WIEGAND RX RX
DATA_0 NO COM
Overlap wires as shown. Use heat gun to set wires.
Load Current @ 12VDC
1A 1-1/4A 1-1/2A 2A 3A
14 14 12 12 10
12 12 12 10 —
12 10 10 — —
10 10 10 — —
10 10 — — —
— — — — —
— — — — —
— — — — —
— — — — —
— — — — —
7-Brown 8-Yellow
EGND TAMPER
OPEN
EGND
COLLECTOR
PIN 1 (Black – Reader NEG)
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
Strip 1/4"
Wire Gauge Charts
Total
One-Way
Length of
Wire Run (ft) 1/4A 1/2A
100 24 20
150 22 18
200 20 18
250 18 16
300 18 16
400 18 14
500 16 14
750 14 12
1,000 14 10
1,500 12 10
5
A8239A • 800-810-WIRE (9473) • www.sargentlock.com
4 PIN CONNECTOR
1-Violet 2-Gray 3-Pink
12/24 VDC DPS
(NC)
(LOCK RELAY)
NEG POS DPS
PIN8 (Yellow – TAMPER)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
PIN 4 (Tan – DPS COM)
PIN 3 (Pink – DPS NC)
Load Current @ 24VDC
3/4A 1A 1-1/4A 1-1/2A 2A
18 18 16 16 14
16 16 14 14 12
16 14 14 12 12
14 14 12 12 12
14 12 12 12 10
12 12 10 10 —
12 10 10 — —
10 10 — — —
10 — — — —
— — — — —
4-Tan
DPS
(COM)
DPS
3A
12
10
10
10
—
—
—
—
—
—