Dhcp - Planet WAP-500N User Manual

The page includes the following common settings in each Internet Connection Type:
Object
• Internet Connection Type
Option: This section may vary depending on the Internet Connection Type.
Refer to settings of each corresponding section from 5.4.2.1 to 5.4.2.4
Domain Name Server (DNS) Address
• Get Automatically From ISP
• Use These DNS Servers
• Primary DNS
• Secondary DNS
WAN Ping
• Discard Ping on WAN
• Accept
• Cancel
4.4.2.1.

DHCP

Select DHCP and the device will automatically obtain IP addresses, subnet masks and gateway addresses from
the ISP.
Description
• DHCP: Dynamic IP addressing assigns a different IP address each
time a device connects to an ISP service provider.
• Static IP: Setting a static IP address allows an administrator to set a
specific IP address for the router and guarantees that it cannot be
assigned a different address.
• PPPoE: Point-to-Point Protocol over Ethernet (PPPoE) is used mainly
by ISPs that provide DSL modems to connect to the Internet.
• PPTP: The Point-to-Point Tunneling Protocol (PPTP) is used in
association with virtual private networks (VPNs).
Select it to obtain the DNS automatically from the DHCP server.
Select it to set up the Primary DNS and Secondary DNS servers
manually.
Enter the primary DNS server address.
Enter the secondary DNS server address.
Check it to enable pings on the WAN interface or disable to block pings on
the WAN interface.
Click Accept to apply the setting.
Click Cancel to cancel the setting.
-36-
User Manual of WAP-500N/WBS-500N