Lightspeed Flexmike User Manual page 9

FLEXMIKE CONTROLS AND CONNECTIONS
3
2
4
1. POWER/MUTE SWITCH: Press and hold to power on, press to mute,
press and hold to power off.
2. MIC 1 STATUS: Lighted to indicate operation status for Flexmike
• Blue: solid = normal operation; Blue: flashing = linking in progress
• Red: solid = muted; Red: flashing = muted while linking in progress
3. MIC 2 STATUS: This light is not used when operating Flexmike with
Multimike system.
4. MICROPHONE CONNECTION: Plug in the optional Lightspeed earset
Microphone (EMA) or the Lightspeed lapel (LMA) here.
5. CHARGING/LOW BATTERY INDICATOR: Lights red when charging,
green when fully charged. When in operation, it turns red to indicate low
battery.
6. MICROPHONE VOLUME UP/DOWN
7. AUDIO INPUT: Plug a laptop, MP3 player or other audio device into this
jack to wirelessly transmit the audio signal to be played through the
system.
8. LANYARD INTERFACE: Insert the lanyard into this hook to wear the
Flexmike.
9. BATTERY DOOR: Remove the battery door to replace the rechargeable
battery pack
10. REGISTRATION: (inside battery compartment - not shown) only used
when adding or replacing Flexmike.
11. SYSTEM ID LABEL
1
6
5
8
7
10
11
9
9