Connect The Power Supply; Optional Connection To Cat 885 Amplifier; Optional - Lightspeed Flexmike User Manual

2B. CONNECT THE POWER SUPPLY
1. Plug the micro USB end of the power cable into the USB port on the back of the
Multimike.
2. Plug the other end of the cable into the USB1 power adaptor.
3. The blue power light on the front of the Multimike will light.
2C. OPTIONAL CONNECTION TO LIGHTSPEED
CAT 885 AMPLIFIER
If you are connecting into a new or existing Lightspeed Cat 885 amplifier, you can use Cat
5 cabling to integrate the two components (a 2' cable is included with the system). This
connection will send the audio from Multimike to the Cat 885 as well as provide power for
the Multimike (no need for an additional AC power connection).
1. Plug one end of the Cat 5 cable into the AUDIO OUT/DC IN jack on the Multimike.
2. Plug the other end into the "SENSOR INPUT" jack on the 885 amplifier.
3. Plug in the Cat 885 into AC power (if it's not already) and the blue power light on the
front of the Multimike will light.
4. Multimike audio levels can be controlled with the Microphone Volume control on
Multimike as well as the CH A control on the 885 amplifier.
USB POWER
5V/0.2A
REGISTER
USB POWER
MIC LINE
+
5V/1.5A
AUDIO IN BAL. AUDIO OUT AUDIO OUT AUDIO OUT/DC IN
USB POWER
5V/0.2A
REGISTER
+
AUDIO IN BAL. AUDIO OUT AUDIO OUT
Power Light
POWER
1
MIC LINE
AUDIO OUT/DC IN
MICROPHONE AUDIO IN TONE
2
MIN MAX MIN MAX TREBLE BASS
13