DFI KS070-AL User Manual page 36

SATA Configuration
This section configures SATA devices. It also shows the information about the installed
SATA drives.
SATA Controller
Enable or disable the Serial ATA controller.
Chapter 7 BIOS Setup
Chapter 7
SATA Speed
Select Serial ATA device speed from these options: Gen1 (1.5 Gbit/s), Gen2 (3 Gbit/s) or Gen
3 (6 Gbit/s).
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Interface).
Serial ATA Port 0 and 1 and Hot Plug
Enable or disable each Serial ATA port and its hot plug function.
SATA Port 0: It controls the signal of the CFast card slot.
SATA Port 1: It controls the signal of the M.2 slot.
36
www.dfi.com