DFI KS070-AL User Manual page 31

4. Insert the Panel PC from the outside surface of the panel into the mounting hole until it is
properly fitted against the panel.
5. Position the mounting clamps along the rear edges of the Panel PC and insert them into the
slits around the Panel PC.
5
6. The first and second clamps must be positioned and secured diagonally prior to mounting
the rest of the clamps. Tighten the clamp's screw using an electric screwdriver by pressing
the white plastic cap onto the back of the panel. The illustration below shows that all
clamps are properly mounted. 210.50
Chapter 6 Mounting Options
Chapter 6
Note:
The flat panel thickness is less than 5mm.
31
www.dfi.com