DFI KS070-AL User Manual page 34

ACPI Configuration
This section configures system ACPI parameters.
Wake on LAN
Enable or disable WOL (wake-on-LAN) to wake the system through an Ethernet adapter.
After G3
Specify which state the system should be in when power is re-applied after a power
failure (G3, the mechanical-off, state).
Always On The system is powered on.
Always Off The system is powered off.
BGRT Logo
Enable or disable the display of an operating system logo or image during boot using
the BGRT (Boot Graphics Resource Table) mechanism.
Chapter 7 BIOS Setup
Chapter 7
CPU Configuration
This section configures the CPU.
EIST
Enable or disable the Enhanced Intel
the balance between system's power consumption and performance. After it is enabled
in the BIOS, you can take advantage of its offering by setting power schemes from the
operating system's power options.
Turbo Mode
Enable or disable processor turbo mode, which allows the processor core to automati-
cally run faster than the base frequency by taking advantage of thermal and power
headroom. Note this option is not available on the Core™ i3 processor.
C-States
Enable or disable CPU power management. It allows the CPU to go to C states when
it's not 100% utilized.
34
SpeedStep Technology, which helps optimize
® ®
www.dfi.com