Figure 19; Figure 19 Placement Of Communication Filters - Bard MULTI-TEC W24AAPA Installation Instructions Manual

Placement of Communication Wire Filters (Daisy Chain and Alternate Methods)
Place filter here
LC6000
Place filter here
(end unit)
Unit 1
NOTE: Line filters can be on either the unit or controller, whichever device is on the end of the chain. No matter
how many units there are, the two end devices will only have ONE communication cable, whereas the
center devices will all have TWO (as shown above). Filters go inside the unit or controller; shown out of
unit above for identification only.
Manual 2100-676B
Page 30 of 88
Daisy Chain Wiring
Unit 1 Unit 2
Alternate Wiring
LC6000*
Unit 2
* LC6000 can be in any position other than start and end

FIGURE 19

Unit 3 Unit 4
Unit 3
Place filter here
(end unit)
... up to 14 units
Unit 5
Place filter here
(end unit)
Unit 4 Unit 5 ... up to 14 units