Installation Diagnostic List; Test Mode - Landis+Gyr ZMQ202 User Manual

6.2.3

Installation Diagnostic List

6.2.4

Test Mode

Note
H 71 0200 0215 f en - ZMQ202 / ZFQ202 - User Manual
Service
Select diagnostic
1.
list
Enter installation
2.
diagnostic list
Select required
3.
value
4. Repeat step 3 for
all values to be
checked
Back to service
5.
menu
Test mode enables you to select which measuring quantity (active,
2 2
reactive, I , U ) is output to the optical test output. Depending on
parameter setting, the resolution of the display register can be increased
for faster testing, using the time-power-method.
Select test mode
1.
Enter test mode
2.
Select required
3.
value
4. Repeat step 3 for
all values to be
tested
Back to service
5.
menu
Example
The first value and value x are examples. The real values are defined in the
parameter settings and are the same as the operating display. Losses are
displayed in conjunction with the optical test outputs as shown in the
following table:
Installation
diagnostic list
First value
Value x
End of diagnostic
list
Test mode
First value
Value x
End of test mode
Landis+Gyr
69/88