4.2
Connect f6
Note
4.2.1
Terminal Connection Diagram
4.2.2
Terminal Layout
Transmitting
contacts
Landis+Gyr
42/88
Assumption of mounted meter
It is assumed that the meter is already mounted. How to mount the meter
is described in section
The f6 is connected according to the Terminal Connection Diagram located
in the front door. The following is an example.
Additional power supply
Tariff control inputs
Alarm contact
Synchronisation input
The 12 spring clamp connectors are located on the transmitting module
and transmit measured values as pulses to telemetering instruments. They
are passive output contacts, i.e. controlled by the receiver.
The function of each connector depends on the connected PCB. Assigning
the functions to the corresponding connector is determined in the software.
The connector numbers remain the same, whichever PCB is connected.
3.11 Mounting f6
.
Pulse transmitting contacts
Energy flow contacts
Static output contact
I1
I1
I2
I2
U1
U2
H 71 0200 0215 f en - ZMQ202 / ZFQ202 - User Manual
Communication unit
RS485
I3
I3
interface
U3
N
Installation / De-installation